How do I setup my Linksys wireless-G Range Expander?

Setting up the Linksys WRE54G Wireless-G Range Expander

  1. Access the range expander’s web-based set up page.
  2. On the WEP page, click the drop-down arrow for Security Mode then select the one that corresponds to the security mode of your wireless router.
  3. Enter the Gateway and the Subnet Mask values in the fields provided.

How do I use my Linksys router as a wifi extender?

Click Connectivity.

  1. Click Internet Settings.
  2. Click Edit.
  3. Select Wireless Repeater.
  4. Enter the main router or access point’s Network name (SSID), Network band and Security mode.
  5. Click to save settings. Click Yes to continue.

What is a wireless-G Range Expander?

The Wireless-G Range Expander (WRE54G) allows you to extend the standard range of your wireless router or access point. This device acts like a signal repeater and expands the range of your wireless network.

How do I setup my WRE54G?

  1. Introduction, Steps 1 – 5.
  2. Step 1: Reset the WRE54G to factory defaults.
  3. Step 2: Set your wireless client to a static IP address.
  4. Step 3: Configure WDS bridging on the target AP.
  5. Step 4: Find and connect to the WRE54G.
  6. Step 5: Connect to the WRE54G.

How do I know if I’m connected to my WiFi extender?

Go to Settings > Status to check the internet status of your extender. If everything is OK as shown below, your extender is successfully connected to your router. Connect your devices to the extender wirelessly or via an Ethernet cable.

How do I access my Linksys extender settings?

Enter http://extender.linksys.com in the Address bar. NOTE: If your range extender is not yet configured, its default IP address is 192.168. 1.1. Once your extender is already configured you will need to look up the IP address in your router’s DHCP table.

By