How does Hondata traction control work?
Hondata Traction Control works by monitoring the ABS wheel speed sensors and reducing engine output when excessive wheel-spin is detected. A dash mountable switch allows the selection of different target slip rates, and software allows the system to be tuned for your specific vehicle setup.
How much HP can Hondata add?
So while a CAI has more peak power – 7.6hp vs 4.8hp for the Hondata program, the Hondata tune has over 50 percent more average power gain over the entire rev range (6.4 hp vs 4.1hp).
How do you turn off traction control on a Hondata?
Also the Hondata software traction is under your control whereas the factory VSA is fixed in parameters and operation. Enabled will enable software traction control. The traction control can be disabled while driving by switching on the cruise control main.
Is Hondata FlashPro worth it?
FlashPro is worth every penny! I’ve had the basemap installed for a month now and it’s like a new car. The mid-range punch is strong! And the traction control alone is worth it.
How do you program a Hondata?
Flash the calibration onto your vehicle. Plug the Flashpro into the OBD2 port with the ignition switched on but the engine is not running. Hold down the program button for 3 seconds and then release. The program light will flash for 1 minute and 30 seconds while the calibration is uploaded.
Can traction control be installed?
Traction control can be fitted to a front-, rear- or all-wheel drive vehicle and the principle is the same no matter which wheels are driven.
How does Haltech traction control work?
Traction control is a control system whereby the ECU will detect wheel spin by comparing the driven wheel speeds to the undriven wheel speeds, and if sufficient slip is detected it will attempt to limit engine power output by cutting fuel or ignition outputs.
Does Hondata have boost by gear?
Enter the duty cycle and boost values into the parameters ‘Pressure vs Duty Cycle’ table. This tells the ECU what duty cycle it needs to obtain a certain manifold pressure. In the ‘Boost by Gear’ table enter your target boost for each gear.