How much does it cost to replace a drive shaft on a Ford f150?
The Best in Auto Repair The average cost for a Ford F-150 axle shaft replacement is between $501 and $573. Labor costs are estimated between $143 and $180 while parts are priced between $358 and $393. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
How do I know what axle my f150 has?
How Do I Find the Axle Ratio and Limited Slip of My Ford Vehicle?
- Locate the Safety Compliance Certification Label on the driver’s side front or rear door panel.
- Find the word AXLE under the bar code.
- Find the two-digit code under AXLE.
Does a Ford f150 have CV joints?
The average cost for a Ford F-150 CV joint replacement is between $563 and $616. Labor costs are estimated between $205 and $258 while parts are priced at $358.
What is an H9 axle on a Ford f150?
A Ford H9 axle code means your truck has a limited-slip differential with a 3.55 ratio. A limited-slip differential (LSD) limits the amount of wheel spin when the driven wheels lose traction as power is applied. It does this by redistributing engine power to the wheels with the most traction.
How much is a drive shaft for a Ford?
This can cost anywhere from $350-$850 depending on location. Again, the cost of parts is around average for all repairs. with labor topping out the rest of the cost at $150-$250 depending on the service center, state, and taxes for that state.
How long do u-joints last on a truck?
In most cases, you have to grease your u-joints every 5,000 miles or so. When you fail to service your u-joints on a regular basis, they will fail. You don’t have to worry about this problem with maintenance free u-joints. Misalignment: This happens when you change the vehicle’s ride height.
What axle ratio is my F-150?
Depending on trim and engine configuration, the 2020 F-150 features an axle ratio of 3.15, 3.31, 3.55, 3.73, or 4.10. As a general rule, higher gear ratios equate to higher towing capacities and lower fuel economy estimates.
How do I know if my CV joints are bad on my f150?
4 Signs of a Bad CV Axle/Half Shaft
- “Clicking” Noises When Turning.
- A Knocking Sound.
- Grease on the Inside or Edge of the Tires.
- Vibration While Driving. This is a tricky one, since there are many things that could cause vibration when you drive.
Do 2WD have CV axles?
Your 2wd does not have a front axle, so no CV Joint. If the truck is 2WD you do not have CV (constant velocity) joints up front. The CV joints are located on either end of the front half-shafts coming off the front differential that drive the front wheels on a 4WD model.
What is a B6 Ford axle?
And, of course, they’ll give you some of the essential info about your axle. Based on the Ford axle code B6, it looks like you have a late model Ford F150 (or similar model) with a limited slip differential and a 3.73 ratio. Ford reused some codes in different years, so the same code may apply to multiple models.
What is a 3.55 axle ratio?
Understanding Axle Ratios Technically, the number should be expressed as a ratio, such as 3.55:1, meaning the drive shaft turns 3.55 times for each turn of a wheel. But that gear ratio would most commonly be referred to as “3.55” or simply “three fifty-five.”