What is the torque setting for wheel bearings?

with no more than 15 to 20 ft. lbs. of torque while rotating the wheel to make sure the bearings are seated.

What is the torque on a wheel hub assembly?

GM Automobile Torque Specifications The torque specifications for GM wheel hubs generally range between 107 to 225 foot-pounds, depending on the year and model.

What is the correct torque for most wheel hub nuts?

The general rule for steel wheel lug nut torque is usually around 80ft/lb, and for aluminum wheels it is around 100ft/lb, this being said you still need to check on the manufacturer’s specifications.

How tight should wheel bearings be on spindle?

Snug them up, but you should be able to move the “washer” behind the nut with a screwdriver used in a prying motion. IOW, they shouldn’t be “too tight” but there shouldn’t be much play either. If you have the nut “tight”, the cotter pin installed, and you can still move the washer with a screwdriver, it’s right.

How tight do you tighten front wheel bearings?

For context, the tolerable end-play for truck wheel bearings is the same: 0.001 to 0.005 inches, also expressed as 1 to 5 mil or 0.025 to 0.127 mm. In other words, it’s perfectly acceptable to adjust wheel bearings so that they are just a little bit loose, but not too loose.

What is the torque specs for the spindle axle nut?

For one-piece spindle nut systems, torque the nut to a minimum of 300 ft-lbs. Do not back off the spindle nut. Engage any locking device that is part of the spindle nut system. If the locking device cannot be engaged when the nut is at 300 ft-lbs, advance the nut until engagement takes place and the nut is locked.

What is the torque for a front axle nut?

Generally, jam nuts less than 2-5/8″ should be torqued to 200-300 lbf-ft; nuts 2-5/8″ and over should be torqued to 250-400 lbf-ft. See chart for exact torque specification. The final step is to use a dial indicator to verify the end play or free movement of the tire and wheel assembly along the spindle axis.