Why does my generator keep blowing fuses?

If your generator keeps blowing a fuse, then the cause is most likely either a current overload in the circuit, a short circuit, or ground fault. If you find none of this, then check if you have the correct size fuse in place because an “under-rated” fuse can keep blowing.

How do I reset my Aqua Rite salt generator?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

How do I reset my Hayward Aqua Trol salt generator?

To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds). Desired Output % Dial 1 to 100% sets the level of cell operation in % of operating time.. Example: 50% (factory default) cell is operating and generating chlorine 50% of the total pump/filter operating time.

Why is my Hayward Aqua Rite salt generator saying no flow?

“No Flow” LED illuminated. The Hayward Aqua Rite has sensed a no flow condition and has stopped generating chlorine. Check that the flow switch is plugged into the connector on the bottom of the control unit and that the wire is not cut or damaged.

How do you stop a fuse from blowing?

To decrease your chances of blowing a fuse, compare the wattage and amperage rating of each of these devices with the amount of power your circuits can handle. This information should be easy to find on their packaging, rating plates or tags.

Why is my salt generator not working?

Water flow The saltwater chlorinator needs a sufficient flow of water for effective operation. A dirty skimmer basket, clogged or dirty filter, and a clogged pump strainer, can cause insufficient water flow for the chlorinator to produce less chlorine.

How do I reset my Hayward Aqua Rite salt chlorine generator?

Reset AquaRite Salt Chlorination Inspect Cell Light If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.

How do you recalibrate Hayward Aqua Trol?

Turn Salt System Off and On With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.

Why does my 15 amp fuse keep blowing?

Having too many devices plugged into a circuit is the most common cause of fuses blowing. This is particularly true of power-hungry devices, such as toasters. Most homeowners assume this is what is causing the problem and work around the issue by limiting plugged-in devices.